|
|
Post by mazdajack on Oct 13, 2022 8:00:29 GMT -5
I have a small pinhole leak in that Coolant hose between water pump and the thermostat housing. The short one that's super awkward. I guess. It's bulging a lot. Anyone no off hand what size hose it is and any solutions to keep it secure so that it doesn't bulge out too much?
|
|
|
|
Post by shiloh66 on Oct 13, 2022 13:36:43 GMT -5
I believe that hose is 1 1/8 inch. I went to napa and bought a piece of gates hose that was industrial quality. Make sure you cut it to proper length when installing it. If it is too long , that may cause it to bulge. Also you will probably have remove the thermostat housing to replace it .
|
|
