|
Post by mazdieselb2200 on Oct 4, 2023 9:12:25 GMT -5
Hello everyone I'm currently trying to install a oil pan gasket on my 1982 B2200 diesel but cant figure out how to install the front and rear cork gaskets if anyone has advice I'd appreciate thanks
|
|
|
Post by rob on Oct 4, 2023 12:20:32 GMT -5
There are microfiche scans above. It will take some time but you might find a diagram. I'll look as I have time. Good luck. Rob
|
|
|
Post by DieselDavo on Oct 4, 2023 18:17:24 GMT -5
As I remember it the end ones were too long and had to be trimmed. I glued the side to the pan with the bolts used to holds them in place until the glue set. Then pushed the front and rear into the engine and put a blob of silicon at the 4 places they met. Don't tighten the pan to soon let the silicon set up a bit with the pan just touching the block.
|
|
|
Post by tempforce on Dec 1, 2023 8:46:27 GMT -5
use gasgacinch automotive adhesive and trim the ends to fit, leave no gapes or you may have a leak. silicon sealers have issues adhering to cork.
|
|